Description – Learn how to make a temperature-controlled Fan using Arduino Uno. This project uses LM 35 as the temperature sensor and the temperature is displayed on a 16*2 LCD screen.
LM35 is a 3-terminal IC that provides analog voltage proportional to the temperature. Higher the temperature, higher is the output voltage. The output analog voltage can be converted to digital form using ADC so that a microcontroller can process it.
The fan is connected to the Arduino board through a single channel relay module. Input pin of the relay is connected to digital pin 2 of the Arduino board.
When the temperature rises above a certain specified value (e.g 40 ⁰ C) the output level of the digital pin 2 is set high and the fan turns on.
Important Links:
LCD connection - https://bit.ly/3nHjkCz
Circuit Connection - https://bit.ly/3aV5qaL
Code -https://bit.ly/3udBKxa
Components Used :
Arduino Uno
LM35 DZ
Single channel relay module
12V power supply/adapter
Breadboard
Jumper wires (male to female and male to male)
Timestamps:
0:00 Introduction
1:00 Connections
3:00 Code
3:38 Final result
Social Media:
Instagram - https://www.instagram.com/spottednemo...
LinkedIn - https://www.linkedin.com/in/nimisha-c...
Check out my other videos:
Stopwatch with Arduino- https://youtu.be/ys0-BWKp76Y
Security Alarm with Ultrasonic Sensor -https://youtu.be/xGdsn14rzc0
Home Automation System -https://youtu.be/CRMbjI9uXYo
LM35 is a 3-terminal IC that provides analog voltage proportional to the temperature. Higher the temperature, higher is the output voltage. The output analog voltage can be converted to digital form using ADC so that a microcontroller can process it.
The fan is connected to the Arduino board through a single channel relay module. Input pin of the relay is connected to digital pin 2 of the Arduino board.
When the temperature rises above a certain specified value (e.g 40 ⁰ C) the output level of the digital pin 2 is set high and the fan turns on.
Important Links:
LCD connection - https://bit.ly/3nHjkCz
Circuit Connection - https://bit.ly/3aV5qaL
Code -https://bit.ly/3udBKxa
Components Used :
Arduino Uno
LM35 DZ
Single channel relay module
12V power supply/adapter
Breadboard
Jumper wires (male to female and male to male)
Timestamps:
0:00 Introduction
1:00 Connections
3:00 Code
3:38 Final result
Social Media:
Instagram - https://www.instagram.com/spottednemo...
LinkedIn - https://www.linkedin.com/in/nimisha-c...
Check out my other videos:
Stopwatch with Arduino- https://youtu.be/ys0-BWKp76Y
Security Alarm with Ultrasonic Sensor -https://youtu.be/xGdsn14rzc0
Home Automation System -https://youtu.be/CRMbjI9uXYo
- Категория
- Ардуино
Комментариев нет.