Arduino CH340 USB Connect - Set 3.3 or 5 Volt (4K)

5 Просмотры
Размещено
The Arduino ProMini uses a USB connector board for programming. The boards need to be set to the voltage of the ProMini (3.3 or 5 volts). It is done by cutting and creating bridges.



SPEC SHEET:
https://www.handsontec.com/dataspecs/module/CH340G%20Serial%20Module.pdf



MATERIALS:
- Arduino ProMini (3.3 or 5 volts)
- CH340 (HW694) USB Connector
- Soldering iron & solder
- Knife or similar to cut tracing for 3.3 volt use
Категория
Ардуино
Комментариев нет.